Skip to content

Painting & Coatings Cost Guide — Ghana (2026)

How much does painting cost in Ghana? Indicative 2026 cost ranges for decorative finishes, epoxy floors, roof waterproofing, commercial and industrial painting in Accra, Tema and Kumasi — with the factors that move every quote. Coralex Painters, since 1972.

Painting in Ghana is priced per square metre after an on-site survey, not from a fixed list, because area, substrate condition, the coating system, and access move every total. As an indicative guide, a graffiato exterior on a 3-bedroom Accra house runs roughly GHS 12,000–18,000 turnkey — indicative and confirmed on survey. Coralex Painters has quoted and delivered painting and protective coatings across Accra, Tema, and Kumasi since 1972.

How Painting Is Priced in Ghana

Reputable painting is quoted by the square metre measured on site, then adjusted for the system specified and the condition of the surface beneath it. A bare, sound new-build wall and a damp, peeling old wall of the same size are not the same job — the second needs preparation, crack remediation, and sometimes a different coating, and the honest quote reflects that.

That is why no genuine contractor in Accra gives a binding total over the phone. The ranges on this page are indicative 2026 figures; the real number is confirmed on a free on-site survey once the area is measured and the substrate is graded.

What Affects the Price

Indicative Cost Ranges by Service

Every figure below is an indicative 2026 range and is confirmed on a free on-site survey. All figures are in Ghana Cedi (GHS).

Decorative & Textured Finishes

ServiceIndicative Ghana (GHS)Note
Graffiato application~40–80 / m²Indicative; confirmed on survey
Graffiato exterior, 3-bedroom house (turnkey)~12,000–18,000Indicative; confirmed on survey
Venetian / marble stucco feature wallpriced per m² on surveyIndicative; confirmed on survey

Epoxy & Resin Floors

ServiceIndicative Ghana (GHS)Note
3D / metallic high-build epoxy floor~150–300 / m²Indicative; confirmed on survey
Standard industrial epoxy floorpriced per m² on surveyIndicative; confirmed on survey

Waterproofing & Protective Coatings

ServiceIndicative Ghana (GHS)Note
Roof / terrace waterproofing membranepriced per m² on surveyIndicative; confirmed on survey
Wet-area / below-grade waterproofingpriced per m² on surveyIndicative; confirmed on survey

Commercial Painting

ServiceIndicative Ghana (GHS)Note
Interior room repaint (labour)~200–400 per roomIndicative; confirmed on survey
Office / retail repaintpriced per m² on surveyIndicative; confirmed on survey

Industrial & Anti-Corrosion

ServiceIndicative Ghana (GHS)Note
ISO 12944 anti-corrosion steel systempriced per m² on surveyIndicative; confirmed on survey
Warehouse / factory floor coatingpriced per m² on surveyIndicative; confirmed on survey

Why Lower-Priced Quotes Cost More

A quote can be made lower-priced in only a few ways: skip the surface preparation, cut the number of coats, use a thinner or lower-grade coating, or specify a system that is wrong for the exposure. Each of those choices saves money on the invoice and loses it on the wall.

Ghana’s climate is unforgiving of shortcuts. On humid masonry, a film-forming coating that traps moisture lifts and peels within a season or two; in Tema and Takoradi, coastal salt corrodes steel that was not protected with the right anti-corrosion system; a roof waterproofed with one thin coat instead of a proper membrane leaks again in the next rains. A lower-priced job that has to be redone is more expensive than the correct job done once. The honest comparison is not price-per-quote — it is cost over the life of the finish.

How to Get an Accurate Quote

  1. Request a free on-site survey — the area is measured and the substrate graded; this is the only way to a real figure.
  2. Agree the system and finish grade — the right coating is fixed against the building’s exposure, not a default.
  3. Receive a written, itemised quote — materials, labour, preparation, and access shown separately.
  4. Confirm scope before work begins — the final figure is signed off in writing, with milestone staging where the project warrants it.

Areas We Serve

Coralex Painters quotes and delivers painting and protective coatings across Greater Accra — East Legon, Airport Residential, Airport City, Cantonments, Ridge, Labone, Dzorwulu, Osu, Spintex, and Tema — plus Kumasi and Takoradi.

Frequently Asked Questions

How much does it cost to paint a house in Accra? As an indicative range, a graffiato textured exterior on a typical 3-bedroom house in Accra runs roughly GHS 12,000–18,000 turnkey, while a single interior room repaint is roughly GHS 200–400 in labour plus materials. Every figure is indicative and confirmed on a free on-site survey, because area, substrate condition, and access change the total.

What is the epoxy floor cost per m² in Ghana? A 3D or high-build metallic epoxy floor in Ghana runs an indicative GHS 150–300 per square metre depending on the system, slab condition, and finish. The figure is indicative and confirmed on survey, because slab moisture and preparation can change the build-up required.

How much does roof waterproofing cost in Ghana? Roof and terrace waterproofing is priced per square metre after a survey of the existing slab, because the membrane system, the surface condition, and the drainage detail all move the figure. The quote is written and itemised, and the figure is confirmed on survey.

What does it cost to repaint an office in Accra? Commercial repaint is priced per square metre after survey rather than as a flat fee, because occupied-premises scheduling, sheen grade, and the number of coats all move the figure. We issue a written, itemised quote so the office can budget accurately — indicative and confirmed on survey.

Ready to start your project?

Request a custom quote. Same-day response.

Request a Specification